FireAsf 🔥
0a131c19fd
[ Upstream commit 20730e9b277873deeb6637339edcba64468f3da3 ]
With one of the on-board ASM1061 AHCI controllers (1b21:0612) on an
ASUSTeK Pro WS WRX80E-SAGE SE WIFI mainboard, a controller hang was
observed that was immediately preceded by the following kernel
messages:
ahci 0000:28:00.0: Using 64-bit DMA addresses
ahci 0000:28:00.0: AMD-Vi: Event logged [IO_PAGE_FAULT domain=0x0035 address=0x7fffff00000 flags=0x0000]
ahci 0000:28:00.0: AMD-Vi: Event logged [IO_PAGE_FAULT domain=0x0035 address=0x7fffff00300 flags=0x0000]
ahci 0000:28:00.0: AMD-Vi: Event logged [IO_PAGE_FAULT domain=0x0035 address=0x7fffff00380 flags=0x0000]
ahci 0000:28:00.0: AMD-Vi: Event logged [IO_PAGE_FAULT domain=0x0035 address=0x7fffff00400 flags=0x0000]
ahci 0000:28:00.0: AMD-Vi: Event logged [IO_PAGE_FAULT domain=0x0035 address=0x7fffff00680 flags=0x0000]
ahci 0000:28:00.0: AMD-Vi: Event logged [IO_PAGE_FAULT domain=0x0035 address=0x7fffff00700 flags=0x0000]
The first message is produced by code in drivers/iommu/dma-iommu.c
which is accompanied by the following comment that seems to apply:
/*
* Try to use all the 32-bit PCI addresses first. The original SAC vs.
* DAC reasoning loses relevance with PCIe, but enough hardware and
* firmware bugs are still lurking out there that it's safest not to
* venture into the 64-bit space until necessary.
*
* If your device goes wrong after seeing the notice then likely either
* its driver is not setting DMA masks accurately, the hardware has
* some inherent bug in handling >32-bit addresses, or not all the
* expected address bits are wired up between the device and the IOMMU.
*/
Asking the ASM1061 on a discrete PCIe card to DMA from I/O virtual
address 0xffffffff00000000 produces the following I/O page faults:
vfio-pci 0000:07:00.0: AMD-Vi: Event logged [IO_PAGE_FAULT domain=0x0021 address=0x7ff00000000 flags=0x0010]
vfio-pci 0000:07:00.0: AMD-Vi: Event logged [IO_PAGE_FAULT domain=0x0021 address=0x7ff00000500 flags=0x0010]
Note that the upper 21 bits of the logged DMA address are zero. (When
asking a different PCIe device in the same PCIe slot to DMA to the
same I/O virtual address, we do see all the upper 32 bits of the DMA
address as 1, so this is not an issue with the chipset or IOMMU
configuration on the test system.)
Also, hacking libahci to always set the upper 21 bits of all DMA
addresses to 1 produces no discernible effect on the behavior of the
ASM1061, and mkfs/mount/scrub/etc work as without this hack.
This all strongly suggests that the ASM1061 has a 43 bit DMA address
limit, and this commit therefore adds a quirk to deal with this limit.
This issue probably applies to (some of) the other supported ASMedia
parts as well, but we limit it to the PCI IDs known to refer to
ASM1061 parts, as that's the only part we know for sure to be affected
by this issue at this point.
Link: https://lore.kernel.org/linux-ide/ZaZ2PIpEId-rl6jv@wantstofly.org/
Signed-off-by: Lennert Buytenhek <kernel@wantstofly.org>
[cassel: drop date from error messages in commit log]
Signed-off-by: Niklas Cassel <cassel@kernel.org>
Signed-off-by: Sasha Levin <sashal@kernel.org>
|
||
|---|---|---|
| .github/workflows | ||
| android | ||
| arch | ||
| block | ||
| certs | ||
| crypto | ||
| Documentation | ||
| drivers | ||
| firmware/tsp_goodix | ||
| fs | ||
| gki | ||
| include | ||
| init | ||
| io_uring | ||
| ipc | ||
| kernel | ||
| kernel_build | ||
| kunitconfigs | ||
| lib | ||
| LICENSES | ||
| mm | ||
| net | ||
| samples | ||
| scripts | ||
| security | ||
| sound | ||
| test | ||
| tools | ||
| usr | ||
| virt | ||
| build.config.aarch64 | ||
| build.config.allmodconfig | ||
| build.config.allmodconfig.aarch64 | ||
| build.config.allmodconfig.arm | ||
| build.config.allmodconfig.x86_64 | ||
| build.config.amlogic | ||
| build.config.arm | ||
| build.config.common | ||
| build.config.db845c | ||
| build.config.erd8825_a25_s | ||
| build.config.erd8825_s | ||
| build.config.erd9925_evt0_s | ||
| build.config.erd9925_evt0_s5300_s | ||
| build.config.erd9925_s | ||
| build.config.gki | ||
| build.config.gki-debug.aarch64 | ||
| build.config.gki-debug.x86_64 | ||
| build.config.gki.aarch64 | ||
| build.config.gki.aarch64.fips140 | ||
| build.config.gki.aarch64.fips140_eval_testing | ||
| build.config.gki.x86_64 | ||
| build.config.gki_kasan | ||
| build.config.gki_kasan.aarch64 | ||
| build.config.gki_kasan.x86_64 | ||
| build.config.gki_kprobes | ||
| build.config.gki_kprobes.aarch64 | ||
| build.config.gki_kprobes.x86_64 | ||
| build.config.hikey960 | ||
| build.config.khwasan | ||
| build.config.mcd | ||
| build.config.rockchip | ||
| build.config.universal2100_s | ||
| build.config.universal8825_s | ||
| build.config.universal9925_evt0_s | ||
| build.config.universal9925_s | ||
| build.config.x86_64 | ||
| build.sh | ||
| COPYING | ||
| CREDITS | ||
| Kbuild | ||
| Kconfig | ||
| linux-stable.sh | ||
| MAINTAINERS | ||
| Makefile | ||
| OWNERS | ||
| README | ||
| README.md | ||
| vendor_boot_module_order_exynos2100.cfg | ||
| vendor_boot_module_order_s5e8825.cfg | ||
| vendor_boot_module_order_s5e9925.cfg | ||
| vendor_module_list_s5e8825.cfg | ||
| vendor_module_list_s5e9925.cfg | ||
| vendor_module_list_s5e9925_b0s.cfg | ||
| vendor_module_list_s5e9925_g0s.cfg | ||
| vendor_module_list_s5e9925_r0s.cfg | ||
How do I submit patches to Android Common Kernels
-
BEST: Make all of your changes to upstream Linux. If appropriate, backport to the stable releases. These patches will be merged automatically in the corresponding common kernels. If the patch is already in upstream Linux, post a backport of the patch that conforms to the patch requirements below.
- Do not send patches upstream that contain only symbol exports. To be considered for upstream Linux,
additions of
EXPORT_SYMBOL_GPL()require an in-tree modular driver that uses the symbol -- so include the new driver or changes to an existing driver in the same patchset as the export. - When sending patches upstream, the commit message must contain a clear case for why the patch is needed and beneficial to the community. Enabling out-of-tree drivers or functionality is not not a persuasive case.
- Do not send patches upstream that contain only symbol exports. To be considered for upstream Linux,
additions of
-
LESS GOOD: Develop your patches out-of-tree (from an upstream Linux point-of-view). Unless these are fixing an Android-specific bug, these are very unlikely to be accepted unless they have been coordinated with kernel-team@android.com. If you want to proceed, post a patch that conforms to the patch requirements below.
Common Kernel patch requirements
- All patches must conform to the Linux kernel coding standards and pass
script/checkpatch.pl - Patches shall not break gki_defconfig or allmodconfig builds for arm, arm64, x86, x86_64 architectures (see https://source.android.com/setup/build/building-kernels)
- If the patch is not merged from an upstream branch, the subject must be tagged with the type of patch:
UPSTREAM:,BACKPORT:,FROMGIT:,FROMLIST:, orANDROID:. - All patches must have a
Change-Id:tag (see https://gerrit-review.googlesource.com/Documentation/user-changeid.html) - If an Android bug has been assigned, there must be a
Bug:tag. - All patches must have a
Signed-off-by:tag by the author and the submitter
Additional requirements are listed below based on patch type
Requirements for backports from mainline Linux: UPSTREAM:, BACKPORT:
- If the patch is a cherry-pick from Linux mainline with no changes at all
- tag the patch subject with
UPSTREAM:. - add upstream commit information with a
(cherry picked from commit ...)line - Example:
- if the upstream commit message is
- tag the patch subject with
important patch from upstream
This is the detailed description of the important patch
Signed-off-by: Fred Jones <fred.jones@foo.org>
- then Joe Smith would upload the patch for the common kernel as
UPSTREAM: important patch from upstream
This is the detailed description of the important patch
Signed-off-by: Fred Jones <fred.jones@foo.org>
Bug: 135791357
Change-Id: I4caaaa566ea080fa148c5e768bb1a0b6f7201c01
(cherry picked from commit c31e73121f4c1ec41143423ac6ce3ce6dafdcec1)
Signed-off-by: Joe Smith <joe.smith@foo.org>
- If the patch requires any changes from the upstream version, tag the patch with
BACKPORT:instead ofUPSTREAM:.- use the same tags as
UPSTREAM: - add comments about the changes under the
(cherry picked from commit ...)line - Example:
- use the same tags as
BACKPORT: important patch from upstream
This is the detailed description of the important patch
Signed-off-by: Fred Jones <fred.jones@foo.org>
Bug: 135791357
Change-Id: I4caaaa566ea080fa148c5e768bb1a0b6f7201c01
(cherry picked from commit c31e73121f4c1ec41143423ac6ce3ce6dafdcec1)
[joe: Resolved minor conflict in drivers/foo/bar.c ]
Signed-off-by: Joe Smith <joe.smith@foo.org>
Requirements for other backports: FROMGIT:, FROMLIST:,
- If the patch has been merged into an upstream maintainer tree, but has not yet
been merged into Linux mainline
- tag the patch subject with
FROMGIT: - add info on where the patch came from as
(cherry picked from commit <sha1> <repo> <branch>). This must be a stable maintainer branch (not rebased, so don't uselinux-nextfor example). - if changes were required, use
BACKPORT: FROMGIT: - Example:
- if the commit message in the maintainer tree is
- tag the patch subject with
important patch from upstream
This is the detailed description of the important patch
Signed-off-by: Fred Jones <fred.jones@foo.org>
- then Joe Smith would upload the patch for the common kernel as
FROMGIT: important patch from upstream
This is the detailed description of the important patch
Signed-off-by: Fred Jones <fred.jones@foo.org>
Bug: 135791357
(cherry picked from commit 878a2fd9de10b03d11d2f622250285c7e63deace
https://git.kernel.org/pub/scm/linux/kernel/git/foo/bar.git test-branch)
Change-Id: I4caaaa566ea080fa148c5e768bb1a0b6f7201c01
Signed-off-by: Joe Smith <joe.smith@foo.org>
- If the patch has been submitted to LKML, but not accepted into any maintainer tree
- tag the patch subject with
FROMLIST: - add a
Link:tag with a link to the submittal on lore.kernel.org - add a
Bug:tag with the Android bug (required for patches not accepted into a maintainer tree) - if changes were required, use
BACKPORT: FROMLIST: - Example:
- tag the patch subject with
FROMLIST: important patch from upstream
This is the detailed description of the important patch
Signed-off-by: Fred Jones <fred.jones@foo.org>
Bug: 135791357
Link: https://lore.kernel.org/lkml/20190619171517.GA17557@someone.com/
Change-Id: I4caaaa566ea080fa148c5e768bb1a0b6f7201c01
Signed-off-by: Joe Smith <joe.smith@foo.org>
Requirements for Android-specific patches: ANDROID:
- If the patch is fixing a bug to Android-specific code
- tag the patch subject with
ANDROID: - add a
Fixes:tag that cites the patch with the bug - Example:
- tag the patch subject with
ANDROID: fix android-specific bug in foobar.c
This is the detailed description of the important fix
Fixes: 1234abcd2468 ("foobar: add cool feature")
Change-Id: I4caaaa566ea080fa148c5e768bb1a0b6f7201c01
Signed-off-by: Joe Smith <joe.smith@foo.org>
- If the patch is a new feature
- tag the patch subject with
ANDROID: - add a
Bug:tag with the Android bug (required for android-specific features)
- tag the patch subject with